[DeTomaso] Greasing the upright Shaft
JDeRyke at aol.com
JDeRyke at aol.com
Mon Jun 30 03:05:32 EDT 2008
In a message dated 6/29/08 4:12:09 PM, asajay at asajay.com writes:
> What does one use to drill a hole in the cast iron upright? What size
> drill, tap and zerk to use?
>
Zerks are all 1/4-28 thread; larger ones are usually installed into various
adapters that have other threads. Zerks only have about 3 threads but that's
apparently enough to hold considerable grease pressure, so there's no sense in
tapping more threads in the upright. Good luck- J Deryke
**************
Gas
prices getting you down? Search AOL Autos for fuel-efficient used cars.
(http://autos.aol.com/used?ncid=aolaut00050000000007)
More information about the DeTomaso
mailing list