[DeTomaso] Rear Camber Bar

[JDeRyke at aol.com]

In a message dated 6/27/08 4:47:11 PM, msm at portata.com writes:

> The design of the mount points for the camber bar looks bad, however if the 
> sheet metal mount point has not bent in 35 years is it bad?  What would you 
> really gain by snugging a bar into the pocket?
> 
Besides the tabs being flimsy, the holes are slotted on each end. You cannot 
tighten the bolts enough to keep the bolts, and bar, from sliding back and 
forth in the slots. So as far as stiffening up the rear, the system doesn't. 
Cheers- J Deryke


**************
Gas prices getting you down? Search AOL Autos for 
fuel-efficient used cars.
      
(http://autos.aol.com/used?ncid=aolaut00050000000007)