[DeTomaso] Rear Camber Bar

[msm at portata.com]

The design of the mount points for the camber bar looks bad, however if the sheet metal mount point has not bent in 35 years is it bad?  What would you really gain by snugging a bar into the pocket?

________________________________

From: detomaso-bounces at realbig.com on behalf of JDeRyke at aol.com
Sent: Wed 6/25/2008 9:08 AM
To: tbaranek at earthlink.net; detomaso at realbig.com
Subject: Re: [DeTomaso] Rear Camber Bar



In a message dated 6/23/08 12:00:53 PM, tbaranek at earthlink.net writes:

> And NONE of the aftermarket snug up to the receiving ends to make them any
> better (and actually make things worse)?
>
None of the commercial aluminum ones do- they fit exactly like the stocker,
at higher weight. As mentioned, only the Hall unit- made of square steel
tubing, powder-coated black, fits tightly into the welded pockets. Any of the others
could be altered to do so by TIG welding and re-polishing. But to my
knowlege, no vendor has yet done this as-delivered. FWIW- J DeRyke


**************
Gas
prices getting you down? Search AOL Autos for fuel-efficient used cars.
     
(http://autos.aol.com/used?ncid=aolaut00050000000007)
_______________________________________________

Detomaso Forum Managed by POCA

Archive Search Engine Now Available at http://www.realbig.com/detomaso/

DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso