[DeTomaso] Mustang rotor/stud problem resolved

[MikeLDrew at aol.com]

In a message dated 7/23/08 13 28 21, guson at home.se writes:


> It sure sounds like he pressed the stud in until a certain protrusion was 
> reached (30 mm) as opposed to the stud head touching the rotor. Once the head 
> bottoms out you'd sooner strip the threads than pulling the head through the 
> rotor so the welding would seem unnecessary to me.
> 

I think the welding was intended to prevent stud rotation, because the studs 
are not splined where they press into the Mustang rotor/hub.

Mike


**************
Get fantasy football with free live scoring. Sign up for 
FanHouse Fantasy Football today.
      
(http://www.fanhouse.com/fantasyaffair?ncid=aolspr00050000000020)