[DeTomaso] Mustang rotor swap question?
Tomas Gunnarsson
guson at home.se
Tue Jul 22 15:06:04 EDT 2008
I was under the impression that the Mustang retrofit required using the Mustang hub and the Mustang (1/2"?) studs.
Tomas
----- Original Message -----
From: <MikeLDrew at aol.com>
To: <detomaso at realbig.com>
Sent: Tuesday, July 22, 2008 8:50 PM
Subject: [DeTomaso] Mustang rotor swap question?
> Hey guys,
>
> I know some of you have successfully installed 60s Mustang rotors on the
> front of your Panteras, and you made it sound pretty easy. With this in mind, I
> shipped a pair to Thierry Monney in Geneva, who was cooking his brakes
> charging down those Alpine passes.
>
> I was under the impression that all you needed to do was knock the Mustang
> studs out, install your old Pantera studs, and with a new set of bearings and
> dust seals, you were ready to go.
>
> He reported that the Mustang studs are substantially larger in diameter, so
> the Pantera studs spin in the rotor hub. I also sent him a Mustang oil seal,
> and the ID of the hole is 49mm, whereas the Pantera seal is 44mm.
>
> So, what is the experience from those of you who have done this, vis-a-vis
> stud swapping and sealing?
>
> Mike
>
>
> **************
> Get fantasy football with free live scoring. Sign up for
> FanHouse Fantasy Football today.
>
> (http://www.fanhouse.com/fantasyaffair?ncid=aolspr00050000000020)
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list