[DeTomaso] Stock Zerk Count and Locations

[Tomas Gunnarsson]

On the dash-1 trans the clutch shaft has one zerk at each end. It uses brass sleeves instead of needle bearings which the dash-2 uses.

Tomas

----- Original Message ----- 
From: "Thomas Tornblom" <Thomas.Tornblom at hax.se>
To: <MikeLDrew at aol.com>
Cc: <detomaso at realbig.com>
Sent: Tuesday, January 08, 2008 8:50 AM
Subject: Re: [DeTomaso] Stock Zerk Count and Locations


> MikeLDrew at aol.com skrev:
>> In a message dated 1/7/08 16 14 37, michaelsavga at gmail.com writes:
>> 
>> 
>>> Calling all zerks!
>>>
>>> I want to do a thorough lube on the car and want to make sure I don't miss
>>> anything that I don't know about.
>>>
>>> Is there a diagram or listing someplace?
>>>
>> 
>> Offhand, I can't think of a single OEM zerk grease fitting anywhere on the 
>> car?   Not on the A-arms, ball joints, tie rod ends, suspension...nowhere?
> 
> There are three on each half shaft.
> 
>> 
>> Some people add them themselves, however.
>> 
>> Mike
>> 
>> 
> 
> Thomas
> _______________________________________________
> 
> Detomaso Forum Managed by POCA
> 
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
> 
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>