[DeTomaso] Techno question: Really dumb--it's the motor mounts
Tomas Gunnarsson
guson at home.se
Sat Dec 13 04:57:14 EST 2008
The contoured sides are to be installed facing each other as you say but one goes on each side of the motor mount, sandwiching the mount.
Tomas
----- Original Message -----
From: "Charles Engles" <cengles at cox.net>
To: <detomaso at realbig.com>
Sent: Saturday, December 13, 2008 1:56 AM
Subject: [DeTomaso] Techno question: Really dumb--it's the motor mounts
> Dear Forum,
>
>
> I am about the install the long awaited drivetrain back into the Pantera tomorrow. In preparation, I pulled out the motor mounts and then I began fiddling with the black rubber (?) hockey puck things. I couldn't be sure how they went back together. In fact, I suspect that they may have been installed previously, by me, ever so slightly wrong.
>
> I pulled out the Pantera Master Parts Catalog and on page 4 of section 60 it shows the flat side of the pucks mounts to toward the cast flat surface of the motor mounts and the contoured, non-flat sides mount toward each other. Is that right?
>
>
> Warmest regards, Chuck Engles
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list