[DeTomaso] Yight flywheel fit.

[michael frazier]

I'm sure it will clearance itself if it's needed.  :)
Michael
BBORR in April> From: hemipanter at hemipanter.se> To: detomaso at realbig.com> Date: Thu, 11 Dec 2008 20:02:02 +0100> Subject: [DeTomaso] Yight flywheel fit.> > It is NEWER "bolt on" nomatter what. I was to mount the new clutch after > fabricating a new flywheel surface plate. A closer look to the release > bearing told me that it was time for a new one, hard pressure plates seem > to kill those things. The inner ball keeper was non exsistent. Then the > flywheel input shaft bearing was good by. Lucky enough I did have some > bearing metal to turn a new one. As cream on the cake the new pressure > plate was a VERY tight fit to the bellhousing, 0,5mm only! And my turner> cant take that big item. ##¤%???1""". This one takes a night of good sleep> to bee in mood to see what to do. > http://www.hemipanter.se/Balance%20kopling.jpg> Goran> _______________________________________________> > Detomaso Forum Managed by POCA> > Archive Search Engine Now Available at http://www.realbig.com/detomaso/> > DeTomaso mailing list> DeTomaso at list.realbig.com> http://list.realbig.com/mailman/listinfo/detomaso
_________________________________________________________________
Send e-mail anywhere. No map, no compass.
http://windowslive.com/Explore/hotmail?ocid=TXT_TAGLM_WL_hotmail_acq_anywhere_122008