[DeTomaso] Yight flywheel fit.

[Göran Malmberg]

It is NEWER "bolt on" nomatter what. I was to mount the new clutch after 
fabricating a new flywheel surface plate. A closer look to the release 
bearing told me that it was time for a new one, hard pressure plates seem 
to kill those things. The inner ball keeper was non exsistent. Then the 
flywheel input shaft bearing was good by. Lucky enough I did have some 
bearing metal to turn a new one. As cream on the cake the new pressure 
plate was a VERY tight fit to the bellhousing, 0,5mm only! And my turner
cant take that big item. ##¤%???1""". This one takes a night of good sleep
to bee in mood to see what to do. 
http://www.hemipanter.se/Balance%20kopling.jpg
Goran