[DeTomaso] Aluminum flywheel
wkooiman at earthlink.net
wkooiman at earthlink.net
Mon Dec 1 17:43:00 EST 2008
FYI - the Fidanza flywheel also comes with dowels, but I don't believe they line up with any holes in the Centerforce PP. It wouldn't be difficult to drill the PP for the dowels.
Will.
-----Original Message-----
>From: Göran Malmberg <hemipanter at hemipanter.se>
>Sent: Dec 1, 2008 12:26 PM
>To: larry at ohiotimecorp.com, 'Barry Seib' <oldwheel at mts.net>, 'DetomasoList' <detomaso at realbig.com>
>Subject: Re: [DeTomaso] Aluminum flywheel
>
>I answered Barry in privat here not to overmail the forum. Studs has one
>good feature,
>it will make it possible to domount without wearing out the aluminium
>treads. A bolt with
>a shoulder will possition the pressure plate as the shoulder could be given
>a tight fit in the
>pressurplate holes. Better still is if the shoulder also goes down a little
>in the flywheels,
>BUT this is provided there is enough material left for treads. We could also
>use Helicoils
>for a more waerproof situation. Back to the studs issue, if the tread does
>NOT have a
>short "shoulder" for the pressureplate possitioning, then we probably should
>use dowel pins
>for this matter.
>Goran
>
>
>I like the idea of studs in an aluminum flywheel too.
>
>What do you thing Goran?
>
>Larry - Cleveland
>
>
>_______________________________________________
>
>Detomaso Forum Managed by POCA
>
>Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
>DeTomaso mailing list
>DeTomaso at list.realbig.com
>http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list