[DeTomaso] Sigh...
Ken Green
kenn_green at yahoo.com
Fri Aug 29 13:52:10 EDT 2008
I thought the Multi Layer Steel (MLS) gaskets were the hot ticket?
http://www.cometic.com/da_viewimage.aspx?da=215
or
http://www.jegs.com/p/Fel+Pro/758649/10002/-1/10193
Ken
--- On Fri, 8/29/08, Thomas Tornblom <Thomas.Tornblom at hax.se> wrote:
From: Thomas Tornblom <Thomas.Tornblom at hax.se>
Subject: [DeTomaso] Sigh...
To: "DetomasoList" <detomaso at realbig.com>
Date: Friday, August 29, 2008, 10:18 AM
Why do I trust instructions like:
"Do not use any type of glue or sealer on these head gaskets. The
special coatings used on the gasket are more than adequate to properly
seal all fluid passages and minor imperfections."
Of course I noticed that the left head was seeping coolant from the rear
top corner when I warmed it up after assembly :-(
The engine runs fine though :-}
I was contemplating putting some sealer around the coolant passages
until I read that...
I'll be ordering some of these for the next time:
http://tinyurl.com/5vsrkv
Thomas
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list