[DeTomaso] Tire Measurements
John Taphorn
jtaphorn at kingwoodcable.com
Sat Aug 16 08:21:10 EDT 2008
Will
You answer is better served with greater precision to your question. This
measurement will depend on a few factors including brand of tire and width
of wheel.
I ran a straight edge across a Michelin pilot tire and measured from the
straight edge to the wheel's inner lip. The lip had a substantial taper on
my 11" Fiske wheel. When measured to the middle of the lip's taper, it was
slightly less than 3/4 inch with ~32lbs in the tire.
You are wise to be careful, I always had Chuck Engles wisdom in the back of
my head when performing this exercise - "You do not want to end up with a
matching set of boat anchors!"
JT
----- Original Message -----
From: "Will Demelo" <wdemelo at cogeco.ca>
To: <detomaso at realbig.com>
Sent: Saturday, August 16, 2008 6:49 AM
Subject: [DeTomaso] Tire Measurements
> I'm ordering new wheels and am trying to figure out the offset I need. Can
> someone tell me what the width is from the inner lip of the wheel to the
> outside edge of the tire on a 335?
> Thanks, Will
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list