[DeTomaso] Horn troubleshooting advice
JDeRyke at aol.com
JDeRyke at aol.com
Sun Apr 6 19:06:29 EDT 2008
I went thru this drill myself, using a VOM, a 12V source and patch cords.
Starting at the horns themselves, after 3 days, I found that everything worked-
except the ground wire that comes out of the stalk button, goes through the
turn signal switch into the wiring loom, then comes back in and solders to the
backside of the stalk.
The return ground wire was 1/8" too short so the wire was under tension, and
the solder had cracked. The fix was to re-heat the original solder blister on
the stalk while pushing in on the wire from the other side. You cannot see
this grounding solder connection, at least on '71-74 Panteras. Your GT-5 rig may
be different. Good luck- J DeRyke
**************
Planning your summer road trip?
Check out AOL Travel Guides.
(http://travel.aol.com/travel-guide/united-states?ncid=aoltrv00030000000016)
More information about the DeTomaso
mailing list