[DeTomaso] Cam question, Pantera ownership is learning to live with disappointment, frustaition and poor.
forestg at att.net
forestg at att.net
Sat Oct 13 15:24:55 EDT 2007
Paul,
I note that you say you set the rotor to cylinder # 8. You should be at #1 when setting to crankshaft TDC marks.
Forest
-------------- Original message ----------------------
From: "Paul A. Rimov" <rimov at charter.net>
>
> Is there any way to check if the cam was installed correctly other than pulling
> off the accessories, drive belt, pulleys and water pump? I can not get my new
> engine to fire. It turns over and over and over and over but just wont fire. I
> have fuel and have double checked every wire, actuator, sensor. I have checked
> the OBD codes on the computer and every thing checks out. I set the timing by
> cranking the engine by hand until the crank shaft was at TDC 0, put the
> distributor in with the rotor pointing at cylinder 8, placed the distributor cap
> on & marked the distributor 1 hooked up all the wires The only thing left I can
> think of is the cam was installed wrong. I don't think I have ever been more
> disappointed, I have spent a year and a ridiculous amount of money putting this
> engine in. I just wanted to have the startablity and drivability of a EFI. I am
> about ready to put the 351c back and put it up for sale. Maybe time for a Z06 or
> Cayman
>
>
> Paul
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list