[DeTomaso] Odd Size Nut On Damper Installation Tool?
JDeRyke at aol.com
JDeRyke at aol.com
Wed Nov 21 02:46:32 EST 2007
In a message dated 11/20/07 5:56:56 PM, kenn_green at yahoo.com writes:
> I measured the nut with a dial caliper, and the lands are 1.275 (within a
> couple thousandths) on all 3 measurements which doesn't match any normal
> fraction (is 1 and 11/40) and is about 32.385 mm.
>
Probably made in a place where that's close enough.... time to get out the
grinder or the welder and make the thing fit a wrench you already own.
Personally, I use a 1/2" drive ratchet & socket. Once done, you won't need to look for
the special wrench or the knuckle-buster. Good luck and be sure to use
anti-sieze on the threads; mine started out threaded 7/16-20, and wore out. So I
tapped the bar to 1/2-20 and used a big allen bolt. Again, the thing wore out.
With my recent harmonic balancer work, its now 5/8-18 and if this one goes away,
I'll have to weld something on- the sides are getting too thin to retap again!
FWIW- J DeRyke
**************************************
Check out AOL's list of 2007's hottest
products.
(http://money.aol.com/special/hot-products-2007?NCID=aoltop00030000000001)
More information about the DeTomaso
mailing list