[DeTomaso] Odd Size Nut On Damper Installation Tool?

[Ken Green]

Nope,
   
      I tried metric pliers and they didn't fit.
   
  Ken

"John Bentley (jab)" <jab at cisco.com> wrote:
  Ken,

You need a metric crescent wench for this nut. :)

JB



-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com]
On Behalf Of Ken Green
Sent: Tuesday, November 20, 2007 5:55 PM
To: detomaso at realbig.com
Subject: [DeTomaso] Odd Size Nut On Damper Installation Tool?

I bought a damper install / puller and would like to use a box end
wrench to turn the nut to pull the damper onto the crank. I measured
the nut with a dial caliper, and the lands are 1.275 (within a couple
thousandths) on all 3 measurements which doesn't match any normal
fraction (is 1 and 11/40) and is about 32.385 mm.

Based on this I'm assuming the nut is a custom part that doesn't match
any standard or metric wrench, but before I give up and use a crescent
wrench, can someone confirm that kits like this have odd ball nuts in
them?

thanks
_______________________________________________

Detomaso Forum Managed by POCA

Archive Search Engine Now Available at http://www.realbig.com/detomaso/

DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso