[DeTomaso] Torque plates
John Bentley (jab)
jab at cisco.com
Sun Nov 18 22:26:25 EST 2007
The plates are used to deform the block (as would happen when a head is
installed) when you bore/hone the block.
JB
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com]
On Behalf Of Orville Burg, II
Sent: Sunday, November 18, 2007 7:19 PM
To: detomaso at realbig.com
Subject: Re: [DeTomaso] Torque plates
Curt,
According to the original post, the purpose is:
I'm going to make a pair of torque plates for using when honing the
cylinder bores.
I didn't know either.
Orville #9469
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com]
On Behalf Of JDeRyke at aol.com
Sent: Thursday, November 08, 2007 1:42 PM
To: pantera at kommevalla.se; DeTomaso at realbig.com
Subject: Re: [DeTomaso] Torque plates
In a message dated 11/8/07 9:17:11 AM, pantera at kommevalla.se writes:
> I'm going to make a pair of torque plates for using when honing
> the cylinder bores. Anyone that have the correct measurements of the
> bolt
patterns and
> the cylinder bores?
>
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list