[DeTomaso] Torque plates
Orville Burg, II
Orville at Rubyglass.com
Sun Nov 18 22:18:41 EST 2007
Curt,
According to the original post, the purpose is:
I'm going to make a pair of torque plates for using when honing the cylinder
bores.
I didn't know either.
Orville #9469
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of JDeRyke at aol.com
Sent: Thursday, November 08, 2007 1:42 PM
To: pantera at kommevalla.se; DeTomaso at realbig.com
Subject: Re: [DeTomaso] Torque plates
In a message dated 11/8/07 9:17:11 AM, pantera at kommevalla.se writes:
> I'm going to make a pair of torque plates for using when honing
> the cylinder bores. Anyone that have the correct measurements of the bolt
patterns and
> the cylinder bores?
>
More information about the DeTomaso
mailing list