[DeTomaso] Bolt length
Doug Braun
doug at silicondesigns.com
Tue Nov 13 15:11:55 EST 2007
Ford didn't use separate washers on the stock head bolts. The hex head of a
stock bolt has an integral flange to spread the load.
Doug Braun
blue 73L #5505
-----Original Message-----
From: Fredrik Gustavsson [mailto:pantera at kommevalla.se]
Sent: Tuesday, November 13, 2007 11:59 AM
To: doug at silicondesigns.com
Subject: SV: [DeTomaso] Bolt length
Thanks,
With or without washer?
Fredrik
-----Ursprungligt meddelande-----
Från: Doug Braun [mailto:doug at silicondesigns.com]
Skickat: den 13 november 2007 20:38
Till: Fredrik Gustavsson; detomaso at realbig.com
Ämne: RE: [DeTomaso] Bolt length
The stock 351C head bolts I have measured out as 1/2NC-13 x 4.25". I put
one through a spare head and it extends 1.05" below the head deck.
Doug Braun
blue 73L #5505
-----Original Message-----
From: detomaso-bounces at realbig.com
[mailto:detomaso-bounces at realbig.com]On Behalf Of Fredrik Gustavsson
Sent: Sunday, November 11, 2007 10:20 AM
To: detomaso at realbig.com
Subject: [DeTomaso] Bolt length
How long are the stock cylinder heads bolts and how deep in the block are
they when installed?
I need to know this before I start to fabricate the torque plate.
Thanks
Fredrik
__________ NOD32 2655 (20071113) Information __________
This message was checked by NOD32 antivirus system.
http://www.eset.com
More information about the DeTomaso
mailing list