[DeTomaso] Bolt length
Will Kooiman
wkooiman at earthlink.net
Mon Nov 12 05:36:33 EST 2007
My ARP head studs have 1.2" of threads that screw in to the block. They
screw in without bottoming out. I didn't measure how deep the threads were.
So, the block has at least 1.2" of threads. Of course, that doesn't mean
that stock bolts on stock heads would use all 1.2".
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of Don Thomas
Sent: Sunday, November 11, 2007 6:55 PM
To: Fredrik Gustavsson
Cc: detomaso at realbig.com
Subject: Re: [DeTomaso] Bolt length
Fredrik Gustavsson wrote:
> How long are the stock cylinder heads bolts and how deep in the block are
> they when installed?
> I need to know this before I start to fabricate the torque plate.
>
1/2-13 x 4-5/16 is the size and length of the 351C head bolts.
I have no idea how far they thread into the block.
As Jack would say... Good luck.
Cheers,
-dt
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list