[DeTomaso] Fw: Transaxle removal
SOBill at aol.com
SOBill at aol.com
Sat May 26 13:50:14 EDT 2007
Doug,
While you have the tranny out, you could remove the bolts on the interior of
the bellhousing which hold the bellhousing to the tranny. As Goran points
out, these bolts serve no structural purpose in the Pantera installation. Goran
has been running a 7L Hemi for years in this configuration with no problems.
With these bolts removed, the tranny can be pulled by removing the exterior
tranny nuts while the bellhousing is left attached to the engine. This means
the starter can stay in place, the sheetmetal bottom cover can remain in
place, and the bellhousing can remain in place. It also means you have lighter
load to be lifted.
If you need to work on the clutch, you can then handle the bellhousing
removal as a sperate issue.
Have fun,
SOBill Taylor
sobill at aol.com
************************************** See what's free at http://www.aol.com.
More information about the DeTomaso
mailing list