[DeTomaso] Electrical question #3

[Charles McCall]

I found an even easier method. 

I looked on the coil to see which post was labeled + and which was labeled
-.

Sometimes I type faster than I think. 

Thanks to all who answered! 

-----Mensaje original-----
De: Tomas Gunnarsson [mailto:guson at home.se] 
Enviado el: Sunday, 06 May, 2007 7:02 PM
Para: 'Pantera'; Charles McCall
Asunto: Re: [DeTomaso] Electrical question #3

Using a voltmeter across the two smaller terminals the terminal with the
lower voltage should be the negative. If they are both the same and close to
12 V, bump the engine over and retry until you see a difference.

Tomas

----- Original Message -----
From: "Charles McCall" <charlesmccall at gmail.com>
To: "'Pantera'" <detomaso at realbig.com>
Sent: den 6 maj 2007 16:47
Subject: [DeTomaso] Electrical question #3


> Hi all,
>  
> Looking at my coil, an MSD Blaster, which connection is negative? 
>  
> I need to connect something to the negative side of the coil - I've got
the
> monster cable going to the distributor (no), and a pair of small wires -
one
> black and one orange that disappear into a wiring harness and then into
the
> bowels of the engine compartment. 
>  
> Any suggestions?
>  
> Thanks!
> _______________________________________________
> 
> Detomaso Forum Managed by POCA
> 
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
> 
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>