[DeTomaso] Fw: Vibration Help
Will Demelo
wdemelo at cogeco.ca
Thu May 3 06:31:21 EDT 2007
Should the motor mount rubbers be bolted together very tightly?
Will
----- Original Message -----
From: "Dan Courtney" <dfcex at pacbell.net>
To: <MikeLDrew at aol.com>; <zumzum at cox.net>; <detomaso at realbig.com>
Sent: Wednesday, May 02, 2007 10:31 PM
Subject: Re: [DeTomaso] Vibration Help
>I have the same problem so I'll also be checking this. Everything else was
>loose from my installer so I wouldn't be surprised. I just hope the
>flywheel bolts are not loose.
>
> Dan
> Dan F. Courtney
>
>
> Excalibur Commercial Real Estate Services
> La Jolla, CA
>
> Phone (858) 551-5455
> Fax (858) 551-5456
>
> ----- Original Message -----
> From: MikeLDrew at aol.com
> To: zumzum at cox.net ; dfcex at pacbell.net ; detomaso at realbig.com
> Sent: Wednesday, May 02, 2007 9:12 AM
> Subject: Re: [DeTomaso] Vibration Help
>
>
> FWIW, I worked on a car once that suffered these sorts of vibrations
> after a clutch change; turns out they hadn't fully tightened the bolts
> between the bellhousing and the block. Even though they LOOKED tight,
> there was some movement available between the two, which only manifested
> itself when the car was underway. Check that out too....
>
> Mike
>
>
> **************************************
> See what's free at http://www.aol.com.
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list