[DeTomaso] Any one live near or in Bristol CT that could look at a project?

[bill gaino]

I found an exellet way to stiffen the rear of the car. Install short hood pins above the taillamp holes. The pins should protrude through the firt layer of the decklid. Under the deck....the ineer structure is an X shape. Placing the pins at the two ends of the X at the taillamps forces the decklid to become a stressed member. My cars decklid would gouge the rearmost corners of the qtr panels. After the pin install, I can through it in the turns and it does not chip the corners. This is very effictive and costs little. I have a few pics of the install if anybody requests.  Bill { the stiff one}

-----Original Message-----
>From: JJD1010 at aol.com
>Sent: May 1, 2007 11:11 AM
>To: ehpantera at yahoo.com, detomaso at realbig.com
>Subject: Re: [DeTomaso] Any one live near or in Bristol CT that could look	at a project?
>
>In a message dated 4/26/2007 6:36:41 PM Central Daylight Time, 
>ehpantera at yahoo.com writes:
> 
>
>I first plan to seam weld everything. 
> 
>.
>Acording to Dennis Quella, you may want to add gussets/doublers across the 
>seams at the outside bottoms of the taillights, bottoms of the A pillars and the 
>seams that attach the roof to the rear quarter panels. He also suggests 
>welding the seams that run on the lower part of the fenders and quarter panels, 
>including the line that runs up to the taillight.
> 
>Jeff
>6559
>
>
>
>
>************************************** See what's free at http://www.aol.com.
>_______________________________________________
>
>Detomaso Forum Managed by POCA
>
>Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
>DeTomaso mailing list
>DeTomaso at list.realbig.com
>http://list.realbig.com/mailman/listinfo/detomaso