[DeTomaso] Torker and Valley Pan
Fredrik Gustavsson
pantera at kommevalla.se
Mon Mar 26 14:14:23 EDT 2007
Which way to block the passage? Weld the intake?
Fredrik Gustavsson
THGTPS07217
-----------------------------------------------
If you refer to:
http://www.bacomatic.org/gallery/album17/A331_vs_Torker_02
you'll see the bottom view of a Torker (on the left) and the
A331 high port version of the same intake. Note the Torker
has a cast in passage underneath the carb to provide heat.
This passage gets very hot. The pan protects the oil from
splashing on the hot exhaust crossover port and turning to
ash. Retain the turkey pan unless the carb heat ports are
blocked or the intake does not have the cross-over passage.
Dan Jones
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
__________ NOD32 2145 (20070326) Information __________
This message was checked by NOD32 antivirus system.
http://www.eset.com
More information about the DeTomaso
mailing list