[DeTomaso] Engine Oil Analysis / Willow Springs Update
forestg at att.net
forestg at att.net
Wed Mar 14 17:27:28 EDT 2007
It sounds like you have a rev kit on your lifters.
-------------- Original message from "Dan Courtney" <dfcex at pacbell.net>: --------------
>
>
> > Donny,
> > The oil analysis showed above average metals from probably bearing, ring
> > and cylinder. It's definaltly coming out.
> >
> > Dan
> > Dan F. Courtney
> >
> >
> > Excalibur Commercial Real Estate Services
> > La Jolla, CA
> >
> > Phone (858) 551-5455
> > Fax (858) 551-5456
> >
> > ----- Original Message -----
> > From: "Donny Williams"
> > To: "Dan Courtney"
> > Sent: Monday, March 12, 2007 3:09 PM
> > Subject: Re: [DeTomaso] Engine Oil Analysis / Willow Springs Update
> >
> >
> >> Dan sounds like a block Brace... I have not seen one of these rascals in
> >> the lifter valley first hand. I run a stud girdle up top, and nothing in
> >> my valley for a block brace. Can you take a picture of it with your cell
> >> phone and shoot it to me? A Block brace should just be bolted into the
> >> block in the valley area. I am not familiar with the springs your seeing
> >> down around your lifters either.... There should be no springs on your
> >> lifters only your Valve springs on top of the head. I need to see what
> >> your looking at.
> >>
> >> You should just see dog bone brackets tying two lifters together with
> >> this block brace over the top you mention. Personally I think we are
> >> looking at the bronze particles from the dizzy gear in your filter. And
> >> at least that is good so far! If it was real bad you would know!
> >>
> >> ----- Original Message -----
> >> From: "Dan Courtney"
> >> To: "Donny Williams"
> >> Cc: "Taphorn, John (KINGWOOD, TX)"
> >> Sent: Monday, March 12, 2007 1:06 PM
> >> Subject: Re: [DeTomaso] Engine Oil Analysis / Willow Springs Update
> >>
> >>
> >>> Donny, no visible particals beyond gold dust. It's a K&N filter and the
> >>> only big stuff is gasket flakes.
> >>> I looked at the roller lifters again. There is a 1/4" gold plate on top,
> >>> part of the Jomar stud girdle I assume, and the lifters are help in
> >>> place by having to fit inside this plate. It looks like the lifter
> >>> springs have to be compressed some how to get them out.
> >>>
> >>> Dan
> >>>
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list