[DeTomaso] Throw out bearing part number needed

[B. Seib]

You're in luck if you have the carrier that takes this bearing. It is
1.6255" inside diameter.

My car was an April 72 and it came from the factory with a 42mm
(1.65")inside diameter bearing and matching carrier. I have not found that
release bearing available anywhere.

Hope you have the right carrier, otherwise I think you can buy the new
carrier and bearing as an assy from PIM or P.Proformance.

Barry

-----Original Message-----
From: detomaso-bounces at realbig.com
[mailto:detomaso-bounces at realbig.com]On Behalf Of Thomas Tornblom
Sent: Sunday, June 24, 2007 3:08 PM
To: Mike Thomas
Cc: detomaso at realbig.com; 'Gary Herrig'
Subject: Re: [DeTomaso] Throw out bearing part number needed


Mike Thomas skrev:
> One more question prior to Saturday's engine drop.
> I need the NAPA or other part number for the clutch throw out bearing.
The
> one I pulled out has no numbers on it.

I installed a Federal Mogul FEM-1625 when I replaced mine.

Apparently there are two different bearings, depending on the transaxle.
I can't say if it depends on age or whatever. My car is a 1984 GT5.

I have even gotten Summit to list them, so you can order them there,
although they are not in stock.


> Thanks
>
> Mike Thomas
>

Thomas
_______________________________________________

Detomaso Forum Managed by POCA

Archive Search Engine Now Available at http://www.realbig.com/detomaso/

DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso