[DeTomaso] Aftermarke taluminum finned valvecovers

[Thomas Tornblom]

Arnold Pleuss skrev:
> Looking for a little insight on how to install a PCV device in the aluminum finned aftermarket valve covers that show up on Ebay regularily. I have a set and each has the round hole at one end that has two notches machined out that allows a twist in oil filler cap to be installed.  
> 
> A round grommet is not going to seal the notches when I install the factory PCV device.

I believe the stamped valve covers have an identical hole and that the 
original grommet will fit.

I have a Ford grommet, with the correct notches, and it fits okay.

> 
> Any guidance willl be appreciated.
> 
> Thanks in advance for any help
> 
> Arnie  Orange #5725

Thomas