[DeTomaso] DONUT PART NUMBER FOR BIG BOR PIPES

[Dave McManus]

Ned,

I battled a long time with the donuts. I found (at NAPA) a donut with an
internal sleeve that stabilizes the fitting. The flange would continually
loosen until I started using this donut. Cost, at NAPA will be between 5.00
and 10.00 each, depending on what the guy at the counter wants to charge.

I will send the part number to you tomorrow. It is at home, I'm at work.

Indy
Dave

-----Original Message-----
From: NED BYRNE, CB SECURITIES, LLC [mailto:nbyrne4 at bloomberg.net] 
Sent: Tuesday, June 05, 2007 8:24 AM
To: DETOMASO at REALBIG.COM
Subject: [DeTomaso] DONUT PART NUMBER FOR BIG BOR PIPES

Can anyone give me the part number and/or supplier for the donut that goes
from 
the stock headers to Hall big bore pipes.  I'd like to put new ones on and
it 
would be nice to pick them up locally.  Thanks

    Ned  "Just Another Blue Pantera"  #2981 "72 Pre-l  Byrne