[DeTomaso] Lean condition and O2 sensors(was fuel pump)
charles buthala
charlesbuthala at yahoo.com
Sat Jul 14 16:40:56 EDT 2007
I did this to my exhaust system.
Bungs are cheep $1
O2 sensors are about 25 to $30 each
I wired them to two jacks in the glove box so that I could hook up a hand held voltage meter. There is a switch to go from cylinders 1-4 and 5-8. It would be nice to have a circuit to even out the signal, but it does work. An analog meter would be better, it evens out the signal some due to mechanical lag.
Charles Engles <cengles at cox.net> wrote:
Dear Uncle Jack,
You wrote:
" Best/simplest/cheapest way is to have someone weld in a
threaded receiver in your two
exhaust collectors and add two wide-band O2 sensors & a gauge
with a selector.
The hookup can be temporary or permanent. This will give a
real-time reading
of rich/lean on both banks of the V-8, well before any loss of
metal occurs. "
Since my current engine rebuild is taking a bit longer than
planned and the headers are off of the engine and car and your
"best/simplest/cheapest way" outlined above is attractive and interesting,
then.......
What would be the budget to obtain and install the above
system? Sources and vendors?
Curious, Chuck Engles
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
---------------------------------
Pinpoint customers who are looking for what you sell.
More information about the DeTomaso
mailing list