[DeTomaso] Turn Signal Indicator Wiring

[SOBill at aol.com]

This may no longer be needed, but, for the archives:
 
 
Control Stalk Harness Wire Color Codes: 
(Note: These color codes apply to the harness integral to the Ford OEM  stalk 
switch assembly. The car chassis wiring uses different color codes for the  
same functions.) 
Turn Signals 
Green/Brown Stripe….Turn Signal Power from the flasher unit 
Green/Red Stripe….Turn Left Power to Lamps……..Get it? Left=Red?  Yikes! 
Green/White Stripe….Turn Right Power to Lamps 
Horn 
Violet/Black Stripe….From low side of horn relay 
White…..Ground for horn relay via stalk horn switch 
Headlamps 
Blue…..Power for headlamps from headlamp switch 
Blue/Red Stripe….Power to Low Beams……Stalk pulled toward  driver 
Blue/White Stripe….Power to High Beams….Stalk pushed away from  driver
 
The corresponding Pantera chassis harness wire color codes  are:
 
Turn signals
 
Pink/Black Stripe.....Turn Signal Power from the flasher  unit
Light Blue/Black Stripe......Turn Left Power to  lamps
Light Blue......Turn Right Power to lamps
 
 
Horn
 
Brown.....From low side of horn relay. The high side of the horn  relay is 
fed 12V via Fuse #7.
Black......To Chassis ground

 
Headlamps
White.......Power for headlamps from headlamp  switch
Gray.......Power to low beams via Fuse #5 and Fuse  #6
Green/Black Stripe.....Power to High Beams via Fuse #1 and Fuse #2  (also 
power to High Beam Indicator)
 
FWIW, Ford shipped replacement turn signal switches without  connectors. I 
have seen two non-interchangable connector types used on Panteras.  The stalk 
harness pins are easily, if you are careful, removed from the  connector by 
depressing the retaining tang with a small screwdriver and gently  pulling on the 
wire.
 
Have fun,
 
SOBill  Taylor
sobill at aol.com



************************************** See what's free at http://www.aol.com.