[DeTomaso] Emergency hood release cable
JDeRyke at aol.com
JDeRyke at aol.com
Fri Dec 28 13:28:36 EST 2007
In a message dated 12/28/07 5:22:48 AM, rickrows at hotmail.com writes:
> Before disaster strikes - what is the recommended method (materials and
> routing) for installing an emergency release for the hood?
>
A 12-14" long piece of braided steel hardware-store cable, a knob or other
pull-thing on one end and a cable clamp on the other. In practice, you drill a
hole sized for a grommet in the side of the toe-box and feed the cable through
so the pull-end dangles above the accelerator pedal and the other end attaches
to the existing latch release. Once done, the cable and its puller can be
tucked in behind the kick-panel so as to not annoy your throttle foot during
driving. I just finished doing this to a Pantera, and the whole job was about an
hour. Full description is in the Tech Service Bulletins. Good luck- J DeRyke
**************************************
See AOL's top rated recipes
(http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004)
More information about the DeTomaso
mailing list