[DeTomaso] clutch slave bleeder valve
Dan Mixon
tipo874 at comcast.net
Wed Dec 26 14:32:00 EST 2007
Sears Hardware stores sell a 10 piece "Midget Combination Metric Wrench
Set". 4, 4.5, 5, 5.5, 6, 7, 8, 9, 10, 11 MM. They are quality made in USA
(at least when I bought mine they were). P/N 42339.
Dan
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of MikeLDrew at aol.com
Sent: Wednesday, December 26, 2007 12:52 PM
To: edlebby at yahoo.com; detomaso at realbig.com
Subject: Re: [DeTomaso] clutch slave bleeder valve
In a message dated 12/26/07 10 46 28, dagny-kr at online.no writes:
> hi all - does anyone happen to know the size of the nut portion of the
> clutch bleeder valve? - put an 8mm to it...too big (and that is the
smallest
> mm i have) - put a 1/4" to it...and too small - ?
>
Besides the 7mm you'll need for the bleeders (check the brake calipers
too--they are probably the same), since you'll be shopping for small metric
wrenches, you'll probably need a 4mm for the tiny screws that secure the
headlight
limit switches.
Not buying the 4mm wrench will virtually guarantee switch or headlight gear
failure within a very short time, while spending the money to have the
wrench
to remove them will almost assuredly ensure their immortality! :>)
Mike
**************************************
See AOL's top rated recipes
(http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004)
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list