[DeTomaso] Clutch MC
MikeLDrew at aol.com
MikeLDrew at aol.com
Mon Dec 24 18:38:29 EST 2007
In a message dated 12/24/07 15 34 34, edlebby at yahoo.com writes:
> what if the push rod was not set exactly right - do i need to go all the
> way back to the point i screwed it on the clevis to adjust it a few turns? - or
> is there a simpler adjustment?
>
The clutch master cylinder spring (internal) will push the pushrod back as
far as it will go. The adjustment of the pushrod in the clevis is what sets
the clutch pedal height. It is uncomfortable, but not too difficult to spin
the pushrod between thumb and forefinger from inside the car. Spin away until
your clutch pedal matches your brake pedal, then tighten the locknut.
You're almost there!
Mike
**************************************
See AOL's top rated recipes
(http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004)
More information about the DeTomaso
mailing list