[DeTomaso] Engine/distributor questions
Paul Timko
thedrol at pobox.com
Sun Dec 16 15:58:19 EST 2007
The issue is with the very bottom of the distributor. Not the portion
where it is clamped to the block. For Mike and Stephan I've attached a
picture. For the rest of you, I'll try and get it posted.
Paul
#9270
MikeLDrew at aol.com wrote:
> In a message dated 12/16/07 12 10 34, thedrol at pobox.com writes:
>
>
>> You are exactly right a standard Ford distributor won't just drop right
>> in. You can drill out the hole (not such a good idea unless you are
>> doing a rebuild) or you can turn the outside of the shaft down.
>>
>
> Is the issue the size of the opening in the block/base of the distributor?
> It's not the shaft that's the issue (the driveshaft) but rather the actual
> base of the distributor, isn't it?
>
> Sounds to me like the best thing to do is leave it alone! Or perhaps have
> the existing distributor rebuilt/rebushed, or converted to a Petronix if it's
> not already an electronic unit.
>
> Thomas, weigh in with your opinion here, as I know I shipped a whole bunch of
> distributor bits and pieces to you as you were tackling this issue.
>
> Mike
>
>
> **************************************
> See AOL's top rated recipes
> (http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004)
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
>
More information about the DeTomaso
mailing list