[DeTomaso] Mirriah Fans
MikeLDrew at aol.com
MikeLDrew at aol.com
Thu Dec 13 19:24:20 EST 2007
In a message dated 12/12/07 22 48 0, Pastafazo at aol.com writes:
> I have a question concerning the attachment of the 10 blade fan unit to
> the
> motor shaft. It seems that the only device that holds the fan unit to to
> the motor is a small hex lock screw. The end of the shaft is not threaded,
> therefore you could not put a nut to secure the fan. I wonder if any of
> you
> have had experience with this. Is a lock screw enough to keep the same
> secure.
>
In a word--yes. The shaft isn't round. It has a flat machined on it, and
the hole in the center of the fan blade has a similar flat, so when the fan
blade is placed upon the shaft, it can't rotate. I can't remember if there is
a groove or indentation machined in the shaft where the set-screw engages it,
but if not, it would certainly be a good idea.
Should the setscrew come loose, airflow could push the fan blade rearwards,
off the shaft and into the front of the radiator, and that would be a bad
thing. :<(
I love my Meriah fans--they work great!!!
Mike
**************************************
See AOL's top rated recipes
(http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004)
More information about the DeTomaso
mailing list