[DeTomaso] Wheel studs
JDeRyke at aol.com
JDeRyke at aol.com
Tue Dec 4 15:07:17 EST 2007
In a message dated 12/4/07 8:36:45 AM, chendric at bellsouth.net writes:
> 1.25mm pitch????? Better check on that. Mine are a standard Ford 12mm X 1.5
> pitch.
>
Yup- correct. But the hardened DeTomaso stud-heads are special to clear the
tight clearances around the rear brake rotor assemblies (either stock or
aftermarket rotors) so if you want drop-in replacement studs for the rear, get stock
studs from your vendors. If you feel like custom-building something to save a
few bucks, go with Dorman replatements from a good auto parts store and cut
the head thicknesses for whatever clearance your setup needs. FWIW, front studs
are less critical in head height but both ends are critical on knurl diameter
and reach. Some things aren't worth fiddling with and IMHO this is one of
those. An escaping wheel assembly will do mucho body damage to a Pantera's
fenders- if you live thru the crash! Good luck- J DeRyke
**************************************
Check out AOL's list of 2007's hottest products.
(http://money.aol.com/special/hot-products-2007?NCID=aoltop00030000000001)
More information about the DeTomaso
mailing list