[DeTomaso] Clutch Master Cylinder

[SEL]

When Mr. DeRyke and Mr. SoBill both say vicegrips...I say yes sir!

As a follow on...I have had mixed advice offline as to what to do with the MC...repair or replace [assume, for purposes of discussion, that the MC is repairable with a gasket, seals, etc., repair kit] - thoughts of the broader forum? - thanks, stephen!


----- Original Message ----
From: "JDeRyke at aol.com" <JDeRyke at aol.com>
To: edlebby at yahoo.com; claywillmott at hotmail.com; detomaso at realbig.com; scpoca at yahoogroups.com
Sent: Tuesday, December 4, 2007 1:26:17 AM
Subject: Re: [DeTomaso] Clutch Master Cylinder

In a message dated 12/3/07 4:28:18 PM, edlebby at yahoo.com writes:


thanks all for the helpful advice...i'll be shouting out again as soon as something goes wrong...!


Incidently, I never have help on these projects, so when I need hands in the front trunk and under the dash to hold a bolt, I depend on a pair of Vice-grip pliers clamped on one end. Removing the nut(s) from the other end then becomes trivial. good luck- J DeRyke


**************************************
Check out AOL's list of 2007's hottest products.
(http://money.aol.com/special/hot-products-2007?NCID=aoltop00030000000001)