[DeTomaso] Distributor engagement
John Bentley (jab)
jab at cisco.com
Wed Aug 29 15:24:18 EDT 2007
You're probably hitting the oil pump drive shaft with the bottom of the
distributor. Just turn the engine over by hand a bit and it will drop
in. If you can turn the crank 2 revolutions, then you can double-check
your static timing.
JB
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com]
On Behalf Of Arnold Pleuss
Sent: Wednesday, August 29, 2007 12:22 PM
To: detomaso at realbig.com
Subject: [DeTomaso] Distributor engagement
HELP!!! Currently trying to install a duraspark distributor back into
the block. It does not want to drop the last 1/4 inch.
I would appreciate any ideas what is needed to get the distributor to
seat correctly.
Thanks in advance for any advice.
Arnie #5725 73L
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list