[DeTomaso] Oscillating vibration
Dan Mixon
tipo874 at comcast.net
Sun Aug 26 20:34:52 EDT 2007
Mike,
There's an alignment arrow stamped on each half. They are light stampings on
mine and are hard too see. When those arrows are aligned they are in phase
and aligned for the factory balance.
Dan
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of Mike Thomas
Sent: Sunday, August 26, 2007 7:31 PM
To: SOBill at aol.com
Cc: Detomaso at realbig.com
Subject: Re: [DeTomaso] Oscillating vibration
The next question I would have then is how large are the splines on a Spicer
HD half shaft. On visual inspection, my U joint ends on the axles appear to
be "in phase", but if the splines are small enough that a visual check may
not be adequate, I'll pull them and take a closer look.
Thanks
Mike
_____
From: SOBill at aol.com [mailto:SOBill at aol.com]
Sent: Sunday, August 26, 2007 4:41 PM
To: mbefthomas at comcast.net
Subject: Re: [DeTomaso] Oscillating vibration
The picture in the link should do the job.
In words, the pivoting axis of inner most joints must be in line with each
other and then the pivot axis of the outermost joints will also be inline
with each other and at 90 degrees to the inner most joint axis.
Even a one slip joint spline alignment error between the inner most joints
can cause a vibration problem.
SOBill Taylor
sobill at aol.com
_____
Get a sneak peek of the all-new AOL.com
<http://discover.aol.com/memed/aolcom30tour/?ncid=AOLAOF00020000000982> .
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list