[DeTomaso] TIG welder
GW
gow2 at rc-tech.net
Thu Aug 23 18:29:17 EDT 2007
I can't speak specifically for that welder but I have the 220v single
phase Lincoln 175 square wave Tig. It has been an awesome machine. I
have TIG'd a couple hundred pieces and it does it like a champ. The
biggest piece was a 1 inch thick aluminum plate 12 inches wide. I
beveled the edge and welded it back. The handle got quite warm as it was
not water cooled (which could be changed if need be) but did an
outstanding job on a hunk of aluminum. It is in fact still in operation
2 years later as an electric motor mount in an industrial roll forming
machine.
http://www.rc-tech.net/per2/shop/Weld/tig.jpg
http://content.lincolnelectric.com/pdfs/products/navigator/im/im687.pdf
In fact, if you know what your doing even a 110v MIG can be pretty
formidable!
Gary
Tomas Gunnarsson wrote:
> I don't own a TIG or am able to weld with one but like you I'd love to have one, especially as this one has plasma cutting. With my experience from MIG welders I'm somewhat skeptical of a 220 unit. With MIGs you'll have a hard time finding a good 230 unit and the general opinion is that 3 phase is the way to go. The power requirements of a TIG should be similar I think.
>
> Tomas
More information about the DeTomaso
mailing list