[DeTomaso] Vibration Help

[Visit ProvaMo.com]

I recently removed my ZF and had a new centerforce flywheel (Summit
700250-48) and clutch installed. The flywheel replaced my original flywheel
with 28oz external balance model.
The new flywheel looked the same as my original with 6 or 7 holes drilled on
one side.
I also thightened my motor mounts. I noticed that the bolts were too long
and it was tightened against the shoulder bolts, not against the rubbers.
The problem is now I've got a bad vibration when revving the motor (not
driving). Idle isn't bad (it's got a fat cam). Just when I rev it to 3 or
4k.
I've got a burnt ignition wire (from the header) and perhaps a fouled plug.
Could this cause a vibration?
Yes a fouled plug could cause a vibration.  No longer hidden by a lopy
cam...

Chuck


I just checked the part # on the flywheel box and it is correct for my
external balance requirement.
Suggestions?
Will (trying to get ready for Pocono) D
_______________________________________________

Detomaso Forum Managed by POCA

Archive Search Engine Now Available at http://www.realbig.com/detomaso/

DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.467 / Virus Database: 269.6.2/781 - Release Date: 4/30/2007
9:14 AM

No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.467 / Virus Database: 269.6.2/781 - Release Date: 4/30/2007
9:14 AM