[DeTomaso] NEXT STEP - NO REAR BRAKES MANGUSTA / Dick Ruzzin

[Michael Shortt]

Geez guys, here we go again, the straight lines are just too easy!

It's well bled, never been loosened before, it's tight in there and you want
to get the nut off!

Is that about the other thread?

Inquiring (dirty) minds want to know!



On 4/6/07, Dickruzzindesign at aol.com <Dickruzzindesign at aol.com> wrote:
>
> Thanks everyone who replied to my request last Monday about my technical
> problem, which I never heard of before.
>
> I now have great front brakes that are well bled, but no rear brakes. I
> have
> a new set of master cylinder seals and am ready to go.
>
> My MC is inside the car, reasonably accessible if you remove the steering
> wheel, drivers seat, top of the IP and also maybe drop the IP itself.
>
> However, there is a big nut at the end of the MC that I can get to pretty
> well.
> I think that if I remove it I will expose the two pistons, can clean that
> end
> of the bore and   install the new seals from there.
>
> Has anyone opened one up before, on the end with the big nut? I expect it
> will be very tight but have some ideas about loosening it.
>
> Thanks.
> Dick Ruzzin
>
> Any other advice?
>
>
> **************************************
> See what's free at
> http://www.aol.com.
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>



-- 
Michael L. Shortt
Savannah, Georgia


This email is protected by the Electronic Communications Privacy
Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
privileged.  If you are not the intended recipient, you are hereby notified
that any retention, dissemination, distribution or copying of this
communication is strictly prohibited.  Please reply to the sender that you
have received this message in error, then delete it.  Thank you